Infinity Tails, Ghozt boards and custom LED’s

Here are some custom LED boards for the side markers!
Here are some custom LED boards for the side markers!
After cutting miniature squares on the plotter and covering each individual chip, we then sprayed the LED strip gun metal which results in the picture above. ( Sounds easy right? Imagine repeating this 8 times. Took longer then what it sounds like.)
After cutting miniature squares on the plotter and covering each individual chip, we then sprayed the LED strip gun metal which results in the picture above. ( Sounds easy right? Imagine repeating this 8 times. Took longer then what it sounds like.)
All custom made wiring with JST connectors.
All custom made wiring with JST connectors.
Distortion in the plexiglass
Trial and error. Ran into a problem to where if you press in the plexi glass with to much pressure it causes distortion. Time to redo (T_T)
Out with the old.
Out with the old.
We finally did it!!
“To infinity & Beyond” After MANY trials and error, we finally did it!! Hard work pays off (:
Much Better! These are straight.
Much Better! These are straight.
Wires need to be ran through the trunk.
Wires need to be ran through the trunk.
Stock harness needs to come out, however need the ability to go back if necessary.
Stock harness needs to come out, however need the ability to go back if necessary.
Steel Stik to keep it together.
Steel Stik to keep it together.
Have to make these perfect, not good enough.
Have to make these perfect, not good enough.
Spend a day making wiring this and organizing the wires.
Spend a day making wiring this and organizing the wires.
All LED's working.
All LED’s working.
Time to make it fit.
Time to make it fit.
Look at all the junk in his trunk!
Look at all the junk in his trunk!
So many wires that have to run inside the trunk!
Job complete!
Job complete!

Share

Leave a Comment

Your email address will not be published. Required fields are marked *